Добро пожаловать в клуб

Показать / Спрятать  Домой  Новости Статьи Файлы Форум Web ссылки F.A.Q. Логобург    Показать / Спрятать

       
Поиск   
Главное меню
ДомойНовостиСтатьиДефектологияПостановка звуковФайлыКнижный мирФорумСловарьРассылкаКаталог ссылокРейтинг пользователейЧаВо(FAQ)КонкурсWeb магазинШкольникамКарта сайта

Поздравляем!
Поздравляем нового Логобуржца feia2727 со вступлением в клуб!

Реклама

КНИЖНЫЙ МИР

Effect of Cooling Procedures over Linear dimensional changes in PMMA   Aqeel Ibrahim

Effect of Cooling Procedures over Linear dimensional changes in PMMA

72 страниц. 2013 год.
LAP Lambert Academic Publishing
Denture bases are commonly made from acrylic resins, which were introduced by Dr. Walter Wright back in 1937. Among these, polymethyl methacrylate (PMMA) is the most commonly used. PMMA material is mostly processed by wet heat and compression molding techniques, which deliver dentures with acceptable mechanical properties. However, certain dimensional changes are known to occur in acrylic resin during or after its processing. These changes hold clinical significance because for better adaptation to oral tissues, denture base material must have dimensional accuracy during and after its processing. However, inaccuracies tend to occur due to unavoidable changes during fabrication such as thermal expansion on heating, contraction on cooling and polymerization shrinkage. The purported significance of this study is to find out the most suitable cooling procedure for achieving maximum dimensional accuracy following a standard heating cycle. This will lead to the fabrication of a...
 
- Генерация страницы: 0.07 секунд -